PRODUCTS
USB 3.2 Type-C to SMA Breakout Board
The SS-USB3.2C-SMA breakout board is designed to test everything USB, from USB-2.0 up through dual-lane USB-3.2. It incorporates a
standards compliant USB Type-C connector (plug or receptacle boards are available) on one end of the printed circuit board and 20 GHz
SMA connectors on the other end of the board. High-speed transmit and receive signals are routed to the SMA connectors via 50-ohm
microstrip transmission lines over Rogers R04350 low-loss dielectric for excellent signal integrity at frequencies up to 30 GHz.
Price: $925.00
Weight: 0.5lb.
Dimensions: 3.8in. x 5.5in x 0.75in
SFP+ to SMA Breakout Board
The SS-SFP-SMA breakout board is an SFP+ Host Compliance Test Board (HCTB). It incorporatesastandards compliant 20-pin SFP+
‘gold finger” board-edge connector on one end of a printed circuit (PC) board and high-speed SMA connectors on the other end of the
PC board. High-speed transmit and receive signals are routed to the SMA connectors via 50-ohm microstrip transmission lines over
Rogers RO4350 low-loss dielectric for excellent signal integrity at data rates up to 11Gbps or more. Low-speed signals Tx_Fault, SDA
SCL, Mod_ABS, and Rx_LOS are routed to standard 0.1 inch header pins. Tx_Disable, RSO, RS1, VccT, and VccF are routed to test points
and include LED indicators. The breakout boards enable test, debug, and development of SFP+ links.
Serial ATA (SATA) to SMA Breakout Board
– Standard configuration includes 4 SMA connectors (TX and RX pairs)
– Optional add-on 4 monitor SMA connectors (for 8 SMA connectors total)
The SS-SATA-SMA breakout board incorporate a standard SATA male connector on one end of a printed circuit (PC) board and highspeed SMA connectors on the other end of the PC board. High-speed 50-ohm controlled impedance microstrip transmission lines of
matched length connect the SATA pins to the SMAS. The breakout boards enable test, debug, and development of SATA links. The
optional monitor connections split off a small portion of the signal, allowing monitoring of the signals on an active SATA link.
Price: $320.00 (Standard Config)
Price: $390 (4 extra SMA monitor connectors)
Weight: 0.25 lb.
Dimensions: 2.5in. x 2.5in
DISCONTINUED - Information for Legacy Support Only
USB-3.0 to SMA Breakout Board, Plug or Receptacle,
– Standard configuration includes 4 SMA connectors (TX and RX pairs)
– Optional add-on 4 monitor SMA connectors (for 8 SMA connectors total)
The SS-USB3-SMA breakout boards incorporate a standard USB-3.0 type-A connector on one end ofa printed circuit (PC) board and
high-speed SMA connectors on the other end of the PC board. Super Speed 5Gbps pins are routed to the SMA connectors via 50-ohm
microstrip transmission lines USB-2.0 signals (VBUS, D-, D+, and GND) are routed to standard 0.1 inch header pins. The breakout boards
enable test, debug, and development of USB-3.0 links.